Copying Functions4-44Maximum Number of Repeat Copy Jobs RetainedYou can use the procedure below to change the maximum number of copy jobs that can be retained in thedocument box.Use the procedure below to change the maximum number of copy jobs retained.1 Press the System Menu key.2 Press [Document Box/Removable Memory] andthen [Next] of Job Box.3 Press [Change] of Repeat Copy Job Retention.4 Use the [+] or [-] key to enter the maximumretention number.You can also enter the number from the numerickeys.A number between 0 and 50 can be entered as thenumber of retained jobs.NOTE: If you enter a value of 0 (zero), you cannot usethe Repeat Copy function.5 Press [OK].DP Read ActionSet the operation when a document is scanned from the document processor. The table below shows theavailable settings.NOTE: The optional document processor is required.Cannot be used when set to [On] in Document Guard on page 9-103.Use the procedure below to set a DP Read Action1 Press the Copy key.2 Place the original.3 Press [Advanced Setup] and then Press [DP ReadAction].4 Select [Speed Priority] or [Quality Priority].5 Press [OK].6 Press the Start key. Copying begins.Document Box/Removable Memory - Repeat Copy Job RetentionSet the maximum number of repeat copy jobs to retain.Use [-]/[+] or the numeric keys to enter a number.*Set this number to 0 to not retain any jobs.(0 - 50)32Cancel OKStatusjob(s)10/10/2010 10:10Item DetailSpeed Priority Priority given to scanning speed.Quality Priority Priority given to image quality.
