Panasonic HomeHawk KX-HNC500 User Manual

3 Tap [Login Settings].4 Next to [Automatic Login], slide the switch to the desired position.To disable automatic login:Slide the switch to the off position.To enable automatic login:Slide the switch to the on position, enter the password and then tap [OK].R To display the characters that you have entered, tap .Changing the login passwordYou can change the login password used in order to connect to your devices while away from home.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Access Point Settings] and select the desired access point.3 Tap [Login Settings] ® [Change Login Password].4 Enter the new password.R To display the characters that you have entered, tap .5 Tap [OK].Note:R The login password can only be changed when you are at home (when your mobile device isconnected to the same wireless router as the access point).Network featuresChanging IP settingsTypically these settings should not be changed.1 From the [HomeHawk] app home screen, tap ® [Settings].2 Tap [Access Point Settings] and select the desired access point.3 Tap [Network] ® [IP Settings].4 Select the desired IP address mode.R In most cases [Auto (DHCP)] is preferred. In this case, no other settings are available on thisscreen.R If you select [Manual (Static)], other settings on this screen become available.5 Configure the settings as needed and then tap [OK].Note:R If you make a mistake while configuring your device to use a static IP address and you can no longerconnect to your device, reset the device’s network settings ( “Resetting an access point”, Page 142).Port forwarding settingsThese settings are only required if you need to configure your wireless router’s port forwarding feature inorder to connect to your devices while away from home.145Using a front door camera and outdoor camera