Panasonic HomeHawk KX-HNC500 User Manual

*1 You can configure the camera so that its LED indicator does not light during normal operation orwhen motion is detected. See “HD camera device profiles”, Page 171.Floor camera LED indicatorOff R No powerR LED indicator is turned off*1Green Registration successfully completed*3 or signal level is strong*2Registration mode, updatingCamera is searching for your wireless routerBlinking every 1.5secondsBatteries for power backup are in useRed Registration failed*3, signal level is weak*2R Streaming data*1 or detecting motion*1R Accessing microSD card (when privacy mode is off)R Camera is out of range of your wireless router*2R LED lights are abnormally hotR Wireless LAN connection failedYellow Not registered to your wireless router (usually for initial setup), or signallevel is good*2Initial setup is being performed using WPS on your routerBlue Registration to your wireless router successfully completed or camera ison*1White Privacy mode is on*1Accessing microSD card (when privacy mode is on)*1 You can configure the camera so that its LED indicator does not light in most states. See “Status”,Page 109.*2 The signal level (strong, good, weak, out of range) is shown after pressing the SETUP button for 3seconds. You can also check the signal level from “Camera signal strength”, Page 109.*3 Lights for 3 seconds after registration is successfully completed or failed.Shelf camera LED indicatorOff R No powerR LED indicator is turned off*1Green Registration successfully completed*3 or signal level is strong*2Registration mode, updatingCamera is searching for your wireless routerRed Registration failed*3, signal level is weak*2R Streaming data*1 or detecting motion*1R Accessing microSD card (when privacy mode is off)31Getting started with the HomeHawk!