Panasonic HomeHawk KX-HNC500 User Manual

– your mobile device's battery does not have adequate charge remaining to use the Automatic ModeSwitching featureIn these cases, start the [HomeHawk] app on your mobile device.Turning geo-fencing on and off1 Access the mode screen ( “Accessing the mode screen”, Page 86).2 Under [Automatic Mode Switching], slide the [Geo-fencing] switch to turn geo-fencing on or off.Configuring geo-fencingYou can specify the settings to be used with geo-fencing.1 Access the mode screen ( “Accessing the mode screen”, Page 86).2 Tap [Edit]3 Tap next to [Geo-fencing].4 Change the settings as required.R Each setting is explained in this section.Setting the base position and radiusIn order to use geo-fencing, you must specify the location and size of the geo-fencing area. The baseposition (usually your home) determines where the geo-fence will be located and the radius determinesthe size of the geo-fencing area.Setting the radius1 Tap the size displayed next to [Radius].2 Specify the desired size, and then tap [Done].Setting the base position for iPhone, iPadOn the map displayed under [Position], tap and hold the area you want to specify for the base position.Setting the base position for Android devicesTap [Use current location] ® [OK]. The location information of the mobile device is obtained and isused as the base location. After this, tap [Check Map] and confirm the location displayed on the map.Note:R Although the position can be set using the map, it may not be set accurately.Setting the mode for when you are not at home (out of radius).You can specify the mode that will be used when your mobile device is outside of the specified radiusaround the geo-fencing area (i.e., when you are away from home).This mode will be activated when all of the selected mobile devices ( “Selecting the mobile devices to usewith geo-fencing”, Page 89) are out of the radius.Tap [Out of Radius], select the mode, and then tap [Done].Setting the mode for when you are at home (in radius)You can specify the mode that will be used when your mobile device is inside of the specified radiusaround the geo-fencing area (i.e., when you are at home).This mode will be activated when any one of the selected mobile devices ( “Selecting the mobile devicesto use with geo-fencing”, Page 89) is in the radius.Tap [In Radius], select the mode, and then tap [Done].88Using a shelf, floor, and window camera