Panasonic HomeHawk KX-HNC500 User Manual

Floor camera setupFloor camera setup (overview)There are 3 basic steps you need to perform in order to connect to the camera from your mobile device.1 Download the appDownload the [HomeHawk] app to your mobile device.See “Downloading the [HomeHawk] app (overview)”, Page 20.2 Set up the cameraUse the [HomeHawk] app to configure the camera to connect to your wireless router, and thenregister your mobile device to the camera.See “Floor camera initial setup”, Page 67.3 Register additional mobile devices (optional)You can register additional mobile devices to the camera, for a total of 8.See “Registering other mobile devices to the floor camera”, Page 69.Floor camera initial setupBefore you beginConfirm the following before you begin.– Make sure you have installed the [HomeHawk] app on your mobile device– Make sure your wireless router and the camera are turned on– Make sure your mobile device is connected to your wireless router– Make sure your mobile device can connect to the InternetNote:R If you have completed this procedure and want to register another mobile device to the camera, see“Registering other mobile devices to the floor camera”, Page 69.R If you experience trouble while performing this procedure, refer to the information in “Initial setup byWPS”, Page 186 and “Initial setup by Basic Setup”, Page 188.Initial setup1 Start the [HomeHawk] app by tapping its icon (shown below).R The end-user license agreement is displayed the first time you start the app.R Confirm all of the displayed permission screens and agree as necessary.R Select your country or region if displayed, and then tap [Next].67Using a shelf, floor, and window camera