Panasonic WJ-HL204/G Operating Instructions Manual

Contents

Panasonic WJ-HL204/G Operating Instructions Manual Manual pdf 41 page image

40Highlight the box under the “Settings” heading andpress the button to define the recording settings.You can set the ips, Quality and Resolution (ips,Quality, Resolution and Dwell for Advanced Modesetup) of the recording for any modes you set up in theMode column. If you do not set the ips, Quality,Resolution and Dwell in the Settings column, therecorder will follow the default settings. See below fordetails.Figure 54 : Schedule - Settings (Advanced Mode) setup screenNote: Descriptions of the Record icons in the “Type” column are as follows:Time-lapse (Time) Alarm-In MotionVideo Loss Video BlindChannels that are not defined will use the setting values of the previous schedule item.When multiple events are detected at the same time from a specific channel, the recorderwill record event video with the high setting values if the ips, Quality, Resolution and Dwellvalues of events are different from each other. However, the ips will be reset to thesupported maximum value when the ips, Quality, Resolution and Dwell are all set to thehighest value. (Advanced Mode Only)Highlight the box under the “ ” heading and press the button to delete the recording settings. You will beasked to confirm that you want to delete the settings.Highlight “Default…” and press the button. The Default screen appears.Highlighting boxes under “ips” and pressing the buttonallows you to set the images per second for Time andEvent recording. You can select from 1.00 ips to 25.00ips.Figure 55 : Default (Schedule - Advanced Mode) screenHighlighting boxes under “Quality” and pressing the button allows you to set the recorded image quality forTime and Event recording. You can select from: “Very High”, “High”, “Standard” and “Basic”.Highlighting boxes under “Resolution” and pressing the button allows you to set the recorded imageresolution for Time and Event recording. You can select from: “Very High” (D1), “High” (Half D1) and“Standard” (CIF).Highlighting boxes under “Dwell” and pressing the button allows you to set the length of time you wouldlike to record for the associated event. You can select from 5 seconds to 30 minutes. (Advanced Mode Only)You can save your changes by highlighting “Save” and pressing the button. Selecting “Cancel” exits thescreen without saving the changes.Pre-EventHighlight “Pre-Event” in the Record menu and press the button, and the Pre-Event setup screen appears.If you do not have Event set up in the Record Schedule, a message will display alerting you to this fact.