Panasonic WJ-HL204/G Operating Instructions Manual

Contents

Panasonic WJ-HL204/G Operating Instructions Manual Manual pdf 62 page image

61select a camera channel in this field, the recorder will search events that are not associated with cameras.You can also toggle On and Off self-diagnostic events as part of your search. The choices are:“System Event”, “Panic Record”, “Check Recording”, “Check Alarm-In”, “Disk Almost Full”, “Disk Bad”, “DiskTemperature”, “Disk S.M.A.R.T.” and “Fan Error”Once you set your desired search conditions, highlight “Search” and press the button to display thesearch results in the “Event Log Search Option” screen. Selecting “Cancel” exits the screen without savingthe changes.Note: It might take long time for the “Event Log Search” according to the selecting conditions.Record Table Search< Compact View >< Standard View >< Expanded View >Recording information about video images currentlydisplayed on the screen displays on the recordingstatus bar. A gray vertical line indicates the currentsearch position. To search specific video, move thevertical line by using the Left or Right arrow buttons onthe front panel or by clicking the mouse on the desiredsegment.If the recorder’s time and date have been reset to atime that is earlier than some recorded video, it ispossible for the recorder to have more than one videostream in the same time range. In this case, theoverlapping time range in the record table will beseparated by a yellow vertical line.Note: The recorded data in the time range locatedafter the yellow vertical line is the latest.Figure 101 : Record Table Search screenThere are three view modes. “Standard view”, “Expanded view” and “Compact view”. Standard view(default) displays combined recording information of all camera channels currently displayed on the screen.In the Standard view mode, selecting “ ” located at the bottom switches to the Expanded view mode. TheExpanded view displays the recording information of each camera channel currently displayed on the screen.Selecting “ ” in the Standard view mode switches to the Compact view mode which displays only the toolbar.Selecting “ ” in the Compact view mode switches to the Standard view mode, and selecting “ ” in theExpanded view mode switches to the Standard view mode.Selecting “ ” or “ ” located at the bottom zooms the record table. Selecting “ ” displays eight hours(1-minute based), and selecting “ ” displays 24 hours (3-minute based) at once. To move to earlier or latertimes that are not shown in the current record table screen, select the arrows located at the end of the timesby using the arrow buttons on the front panel.Note: If the recorder has images recorded in more than one recording mode in the same timerange, the recording status bar displays recording information in the following priorityorder: Panic  Pre-Event  Event  Time. The color of the bar indicates differentrecording modes: Red for Panic, Yellow for Pre-Event, Purple for Event, and Blue for Time.Selecting “ ” located at the bottom displays the “Calendar Search” screen. See the following “CalendarSearch” section for details.Selecting “ ” located at the bottom displays the Search menu.Go to : Displays the first or last recorded image, or searches by date and time (see theprevious “Searching Video – Go to” section of this chapter for more details).Clip Copy : Clips a video segment and saves it (see the following “Clip Copy” section formore details).Figure 102 : Search menuEL-Zoom : Zooms the current playback image.Slow Play : Plays video at low speed (x1/2, x1/3, x1/4, x1/6 and x1/8).