Panasonic WJ-HL204/G Operating Instructions Manual

Contents

Panasonic WJ-HL204/G Operating Instructions Manual Manual pdf 46 page image

45by highlighting that item and pressing the button. Highlight “OK” and press the button to accept yourchanges.Highlight the desired box under the “PTZ” heading, andpress the button. A list of PTZ presets appear.Select the preset position for each PTZ camera, whereyou want PTZ cameras to move to whenever therecorder detects motion on the selected camera’sinput.Highlight the desired box under the “Spot Monitor”heading, and press the button. A list of Spotmonitors and cameras appears. Each Spot monitorcan be associated with a camera. The recorder willdisplay the associated camera on the Spot monitorwhenever it detects motions on the selected camera.Figure 69 : Motion Detection - Actions 2 screenYou can save your Motion Detection changes by highlighting “Save” and pressing the button. Selecting“Cancel” exits the screen without saving the changes.Video LossHighlight “Video Loss” in the Event menu and press the button. The Video Loss setup screen appears.Highlighting the box under the “Video Loss Interval”heading allow you to set the duration of a signal lossbefore the recorder will report a Video Loss. Therecorder will not consider any signal loss from acamera to be a Video Loss if the detected signal loss isshorter than the interval set on this screen.Highlight “Use Ignoring Time” and press the buttonto toggle between On and Off. When set to On, therecorder will ignore video loss events occurring duringthe preset period. Highlighting “Time Setup...” andpressing the button allows you to set up eventignoring time.Figure 70 : Video Loss - Settings screenNote: The record action for motion events will not be affected by the Video Loss ignoring function.Highlight the “Actions 1” and “Actions 2” tabs and the Video Loss Actions 1 and Actions 2 screens display.The recorder can be set to react to video loss differentlyfor each camera. Each camera can be associated withanother camera, trigger an Alarm Output Terminal,sound the recorder’s internal buzzer, notify a number ofdifferent devices, move PTZ cameras to presetpositions, and/or display a camera on a Spot monitor.Highlight the box under the “Record” heading andpress the button. A list of cameras appears. Youcan associate as many cameras with that camera asyou wish. If the recorder detects video loss on theselected camera, it starts recording video from all theassociated cameras.Figure 71 : Video Loss - Actions 1 screenNote: For the Record action, the camera you select should be set to the Event or Time & Eventrecording mode in the Schedule screen.