Panasonic WJ-HL204/G Operating Instructions Manual

Contents

Panasonic WJ-HL204/G Operating Instructions Manual Manual pdf 64 page image

63You can also narrow your event search by selecting the “Option…” and setting up the new search condition.You can search video from the first to last recorded images, oryou can set the start and stop times and dates.Highlight the box beside “From” and press the button totoggle between On and Off. When set to Off, you can enter aspecific Date and Time. When set to On, the search will befrom the first recorded image.Figure 105 : Motion Search Option screenHighlight the box beside “To” and press the button to toggle between On and Off. When set to Off, youcan enter a specific Date and Time. When set to On, the search will be from the last recorded image.Highlight the box beside “Type” and press the button. You can select between “Motion Search” and“Museum Search”. “Motion Search” detects motion in the defined area. “Museum Search” detects if adefined object has moved.Highlight the box beside “Zone” and press the button. An image from the video appears with a gridoverlaid. You can turn sensor blocks On and Off to define the area of the picture in which you want to searchfor motion.Note: Defining the area of the image in which you want to search for motion is nearly identical tosetting up the recorder for “Motion Detection”. Please refer to “Motion Detection” in“Chapter 3 -- Configuration” for more detailed instructions on setting up the detectionblocks.When setting the “Museum Search Zone”, the zone should be placed inside of the borderline of the target object. If the selected block is placed on the border line, the sensitivity ofthe “Museum Search” may decrease.The zone should be placed or focused on the centre or, at least, within the outline of targeted object.Highlight the box beside “Sensitivity” and press the button. You will be able to select from 1 (lowsensitivity) to 255 (high sensitivity).Highlight the box beside “Min. Blocks” and press the button. You will be able to set the number of sensorblocks that must be activated.Once you set your desired search conditions, highlight “Search” and press the button to display thesearch results in the Motion Search Option screen. Selecting “Cancel” exits the screen without saving thechanges.When you search for motion events of another camera, you will be asked whether or not you want to deletethe previous search results from the list.Clip CopyVideo clips can be copied on an external USB flash drive. The copied video clips can be viewed oncomputers. Connect the USB flash drive to the Mouse / Copy Port of the recorder before starting followingoperations.Selecting A-B Clip Copy in the Search - Export menu or pressing the [COPY] button during the playback willset the starting point of the video to be clip copied, and the icon displays at the bottom-left corner of thescreen. Selecting A-B Clip Copy in the Search - Export menu or pressing the [COPY] button again will setthe ending point of the video to be clip copied by displaying the Clip Copy screen.Pressing and holding the [COPY] button for more than three seconds while in the Search mode or LiveMonitoring mode initiates the One-Touch Clip Copy function. The last recorded image will be the endingpoint of video to be clip copied, and the system will automatically begin to calculate the possible video datasize that the selected storage media can handle.Select Clip Copy in the Search - Export menu or press the [COPY] button while in the Search mode or LiveMonitoring mode, and the “Clip Copy” screen appears to allow clip copy setup.