9 – Specifications : Dimensional drawingTASCAM DM-3200 Owner’s Manual 105Dimensional drawingMessages and troubleshootingThis provides an alphabetical list of the messagesthat you may see on the DM-3200, which provideinformation on the operation that you are performing.Not all of these messages are error messages.“Information” messages, i.e. those which pop upbriefly and provide information about a change instatus, etc., are marked with a ●.“Confirm” messages, where a response may be nec-essary (usually confirm with the ENTER key or can-cel with the cursor keys) are marked with a ✔.Messages demanding action other than a simple con-firmation are shown with a (✖), but even these do notnecessarily indicate an error.Figure 9.1: Dimensional drawing MM v MM v MM v MM vMM v MM vAction Message Meaning● Already assigned. The RECORD key has already been assigned to a remote unit.✖ Automation data and Current Status usedifferent Fs.Press ENTER to continue.The automation data uses a sampling frequency of a different value from thecurrent sampling frequency.✖ Automation data and Current Status havedifferenttimecode types.Press ENTER to continue.The automation data uses a timecode of a different frame type from the currenttimecode.● Automation data was recalled. The selected automation data has been recalled into memory.● Automation data was stored. The current automation data has been stored to card.✔ AUX 1-2 LevelSet up Ch parameters?Press ENTER to confirm,or a cursor key to cancelUsed when batch copying parameters from channel to Aux 1-2 settings.Table 9.2: Popup messages