Tascam DM-3200 Owner's Manual

Also see for DM-3200: Quick reference Manual Software guide Application guide Release notes

Contents

5 – Channel modules : Module setup72 TASCAM DM-3200 User’s ManualYou can also set all, odd-numbered, even-numberedor blocks of eight channels to the same value usingthe BATCH SETUP facility at the bottom of the screen.Use the ENTER key to SET the value set with the POD3 encoder to the channels chosen with POD 4.Delay You can “slip” modules relative to each otherin order to compensate for microphone placement,etc. This is the second tab of the DIGITAL TRIM/DELAYscreen (it can also be set from the individual modulescreens).As with other screens, you can use the cursor tomove around and highlight the settings for four mod-ules, and the POD encoders to adjust these settings.The BATCH SETUP works in the same way as the digitaltrim described above, with a few additions.First, POD 1 can be used to change the position ofthe delay between pre-and post-fader for all chan-nels. Additionally, POD 2’s encoder changes the unitin which delay is measured between samples andmilliseconds.POD 3 and 4 and the ENTER key work in the sameway as they do for the digital trim.In addition to the channel delay, aux, buss and stereomodules can also have delay added.The operational difference between this and thechannel delay screen is that the pre/post setting is notavailable on this screen.Stereo linkingYou can link two modules (channel modules, bussesand aux sends) as stereo pairs when working withstereo input sources or stereo effect sends, etc.When modules are linked, setting the followingparameters (where these are available) on one of thepaired modules echoes the settings on the other mod-ule of the pair:• Digital trim• Gate settings• Compressor settings and insertion point• EQ settings• Aux send levels/pan-balance setting/pickoff point• Mute• Fader level• Assignment• Delay time• Solo settings• Grouping• Automation status• Pan modeWhere these settings are made using physical con-trols, moving one control of the pair will move theother control of the pair, and will affect the settings.Figure 5.20: Channel delay screenFigure 5.21: Master delay screen