TASCAM DM-3200 User’s Manual 816 – EffectsThe DM-3200 incorporates two internal effects: a TASCAM multi-purpose effect and a TC Works reverb. Thissection discusses the setup and use of these effects.Routing the effectsAs explained in “Routing” on page 47, internal effectinputs and outputs are treated as sources and destina-tions for routing.The two screens shown here are examples of how theinternal routing is used with the internal effects.In the OUTPUT routing screen, the Aux sends areselected as outputs, and the terminal destination isselected as one of the internal effects.Here, Aux 5 and Aux 6 are selected as aux sends toeffect 1 (effect 2 would be set up in the same way).For the return, the INPUT screen is used. The source isset to EFF RTN (effect return) and channels 17 through20 are selected as effect returns.WARNINGSince there are no dedicated effect returns, the chan-nels used for returns also have aux feeds that may acci-dentally be used to feed the effects being returned onthat channel. If this is done, there will be a feedbackloop that may damage your hearing, and your monitor-ing equipment.Setting up the effectsThe EFFECT key brings up the effect screens, wherethe basic setup of the internal effects is done.First, an effect is recalled from the preset library, orfrom a setting previously stored on a CF card.When the effect setting has been recalled, it may beused as it is, or edited using the editing screen.After pressing the EFFECT key, pressing the POD 2switch brings up the effect 1 library, for managingthe library effects for the first effect loop, and press-ing the POD 4 switch brings up the effect 2 library,for managing the other effect loop (shown in Figure6.2, Effect library screen below):Figure 6.1: Internal effect send and return routingFigure 6.2: Effect library screen