5 – Channel modules : SnapshotsTASCAM DM-3200 User’s Manual 79SnapshotsMixer settings can be stored in a library and recalled,either manually from the control surface, or remotelythrough MIDI Program Change messages.Snapshots contain the following data:• EQ parameters• Dynamics parameters• Fader and mute settings• Groupings and group settings• Aux send settings (level, status, pan-balance)• Pan and balance settings, image, mono switch• Surround parameters and pan mode• Link settings• Digital trim• Phase switch• Digital delay time and point• Buss, stereo and direct assignments or surroundassignments• Effect parameters• routing settingsThese are all stored together with a transition time,which allows faders to move gradually from oneposition to the new position.In addition, there are also some “safety switches”which prevent certain parameters being re-set whenthe snapshot is recalled (for example, it might betedious to have all signals re-routed when a newsnapshot is recalled).Each snapshot can, of course, be named for easy rec-ognition later.Snapshot library managementThe snapshot library screen is accessed through theLIBRARY key:If the snapshot library is not shown, use the POD 1encoder and key to select the snapshot library, asshown in Figure 2.27, Library selection pull-upmenu.As the wheel or POD 4 encoder is used to scrollthough the list of stored snapshots in the current bankor preset list, the representation of the current faderlayer in that snapshot is shown on the right of thescreen (the current settings are provided for referenceon the left of the screen).The RECALL SAFE list on the lower left of the screenallows various parameters to remain unchanged onrecall when a snapshot is recalled. These are:• I/O routing and buss assignment settings• Mute and fader group assignments• Current effect settings• The OTHER parameters (i.e. those not listed above,allowing you to change only grouping, for exam-ple, while keeping fader settings, EQ settings androuting).• Use the POD 3 switch or the cursor at theRECALL on-screen button to recall the currentlyselected library entry. A popup messageappears briefly.Figure 5.36: Snapshot library