3 – Connections : Clock settingTASCAM DM-3200 User’s Manual 45Changing the clock If the desired clock sourcehas a frequency selection option, select thefrequency.The stereo digital inputs (D-IN1 and D-IN2) can havetheir sampling frequency manually set here (but if thefrequency converter is turned on, they cannot act asclock sources). To enable the manual setup for bothdigital inputs, which overwrites the embedded C bit(channel status bit) information, check the checkbox,and select the sampling frequency. Note also that ifthe optional AES/EBU slot card is fitted, the settingsmade here are applied to this card as well.The following options relate to the different clocksources available:When you have selected the appropriate option forthe clock source, move the cursor to the checkboxand press ENTER.A checkmark (✔) appears in the box if a valid clocksignal is present, a cross (✘) if it is not present, and aquestion mark (?) if the clock signal is out of range.An appropriate popup message is shown in the eventof an error in the selected clock signal.If the clock signal is a valid one, and one which canbe used, an appropriate popup message (dependingon the action selected when the clock is changed(“Clock change action” on page 44) is shown).Press ENTER to change the clock, or a cursor key tocancel the action.Clock phase The phase of the clock signalreceived at the WORD SYNC IN or transmitted orpassed through the WORD SYNC OUT/THRU termi-nal (see also “WORD SYNC (IN and OUT/THRU)”on page 42) can be inverted using the on-screenphase controls.OUT SPEED Note that in high-speed mode, theclock transmitted from the WORD SYNC OUT can beeither the high-speed (88.2/96) clock or the corre-sponding normal speed (44.1/48) clock.Normal High-speedInternal 48K/44.1K 96K/88.2KWord (WORD SYNC) connection 48K/44.1K 96K/88.2KCascade No optionsDigital in 1/2 Manual setup, 48K/44.1K Manual setup, 96K/88.2KTDIF 1/2/3 No optionsADAT 48K/44.1K 96K/88.2K (note that this is dual-line inputat high speed)AES card 1/2, 3/4, 5/6, 7/8 1/2, 3/4, 5/6, 7/8TDIF card No optionsADAT card 48K/44.1KAD/DA card No options—this card is not capable of acting as a clock sourceFireWire card TDM format (clock is transmitted on SLRCK)