Tascam DM-3200 Owner's Manual

Also see for DM-3200: Quick reference Manual Software guide Application guide Release notes

Contents

5 – Channel modules : Global module settingsTASCAM DM-3200 User’s Manual 61AUX1-2 button (on buss and stereo modulesonly), allowing the buss or stereo mix to be routedthrough to the aux 1-2 pair (typically for studio fold-back purposes).STEREO button (on buss and aux modules only)allowing you to route the buss or aux send to the ste-reo buss.Group assignment displays Display, but donot allow change on this screen, any fader or mutegroup assignments.NOTEThe buss assignments of channel modules are notshown on the display, as the appropriate buss assignindicators light to show the buss assignments when achannel module is selected.Fader controlFrom the METER/FADER screens, select either the CHFADER or MASTER M/F tabs:In the channel fader screen shown here, the currentfader and pan positions of all 48 channel modules areshown.Moving the cursor around this screen highlights pancontrols or faders in blocks of four (you can also usethe channel SEL keys to jump around the screen).Use the four POD encoders to adjust the on-screencontrols.Mute status and links are also visible on this screen.Note that in surround mode, the surround L-R pan-ning is displayed and set here using POD 1 when theon-screen pan controls are highlighted.To set a master level in blocks of eight channels,move the cursor to the bottom right of the screen(SETUP) and then use POD 3 encoder to adjust thefader level. POD 4 selects the group to be set (ingroups of eight channels), or all channels (ALL).Press the on-screen SET button when done. A popupmessage asks you to confirm the setting (ENTER) orcancel the operation (cursor key).Master screen The MASTER METER/FADER screenworks in a similar way. The top of the screen showsthe buss, aux send and stereo meters (metering pointsselected by moving the cursor to METERING POINT, andusing the wheel and ENTER to set the point).Buss and aux levels are selectable in groups of 4, andthe levels can be adjusted as with the channels usingthe POD encoders.The SETUP section of the screen allows setting of thefirst or second eight buss levels, the aux levels, or allaux and all buss levels, in the same way as for thechannel modules using POD 3 to set the level, andPOD 4 to select the target, with the ENTER key usedto confirm the setting.Figure 5.3: Channel fader screenFigure 5.4: Master fader screen