14 SMart eSolutions126 Xerox WorkCentre 4250/4260 Series System Administration GuideSMart eSolutions Information1. Open your Web Browser and enter the TCP/IP address of the machine in the Addressor Location field and press [Enter]. Your Browser will display the machine Home Page.2. Click the [Status] tab.3. Click [SMart eSolutions].4. The device communication section indicates if your device is successfullycommunicating with Xerox. If there is an error in communication, select the[Settings] button to update the Internet proxy settings.5. If you click [Settings], you will be prompted to enter the administrator user nameand password. The default is [admin] and [1111].6. In the Enrollment area, click or verify the [Enrolled] radio button.Enrollment specifies whether or not the printer will communicate with Xerox. Theoptions are:• [Enrolled] — Communication with Xerox is enabled. This is the default state forthe printer.• [Not Enrolled] — Communication with Xerox is disabled. Select this option tostop communications with Xerox. When you click [Not Enrolled] a windowappears to confirm that you want to deactivate SMart eSolutions enrollment.Click [OK] to deactivate, then click [Apply] to save the selection.Machine Serial Number displays the serial number of the printer.7. In the Communications Setup area, [Daily Transmission Time] lets you specify thestart time (hour and minute) when SMart eSolutions communication occurs withXerox.8. If the HTTP Proxy Server is not fully configured, or you want to change or view thecurrent configuration, click [Configure].9. On the HTTP Proxy Server page, click [Enabled], enter the HTTP proxy settings, thenclick [Save].10. To automatically detect HTTP Proxy Server settings, click [Enabled] for Auto DetectProxy Settings.NOTE: Automatically detecting proxy settings may overwrite manual settings.Disable Auto Detect Proxy Settings to ensure use of manual settings. The AutoDetect process will first use the manual settings to access the Internet. If this fails itwill then use WPAD to auto detect proxy settings. If WPAD fails it will then try a directconnection. Manual settings will be overwritten if new proxy settings are found.11. Use the [Test Communication Now]... button on the Smart eSolutions setup page toverify that the communications setup parameters are correct. This button is enabledwhen the SMart eSolutions Enrollment is enabled.12. Click [Apply] to save changes.