4 Print Drivers40 Xerox WorkCentre 4250/4260 Series System Administration Guide13. Click on the [OK] button to install the printer driver.14. Click on the [Have Disk] button and browse to the location of the printer driver andclick on the [OK] button.15. Select the Printer Model and Click on the [OK] button.16. Click on [Yes] if you wish to make this the default printer.17. Click on the [Next] button.18. Click on the [Finish] button.Raw TCP/IP Printing (Port 9100)Raw TCP/IP is a printing protocol that is similar to LPR printing. Also known as a direct TCP/IPconnection or sockets interface, it sends information directly to the machine and does notrequire a Line Printer Daemon (LPD). The advantages are that connections stay open formultiple print files and spooling is not needed, therefore, printing is faster and more reliablethan LPD printing. Raw TCP/IP printing is contained in Windows 2000 and other third-partyapplications and operating systems.Raw TCP/IP Printing is enabled by default for port 9100.Information ChecklistSee Chapter 3, Configure Static IPv4 Addressing using the Machine User Interface,Information Checklist on page 13.How to Configure Port 91001. At your workstation, open the Web browser and enter the TCP/IP address of themachine in the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Connectivity] link.5. Click on the [Protocols] link.6. Select [Raw TCP/IP Printing] in the directory tree.7. Click the [Enabled] checkbox to enable the Protocol.8. Enter the required port number (1 - 65535).9. Click on [Apply] to accept the changes or [Undo] to return the settings to theirprevious values.NOTE: The settings are not applied until you restart the machine.10. Click on the [Status] tab.11. Click on the [Reboot Machine] button and click on [OK] to reboot machine. Thenetwork controller takes approximately 60 seconds to reboot and networkconnectivity will be unavailable during this time.