Standard AuthenticationXerox WorkCentre 4250/4260 Series System Administration Guide 1312. Ensure that the Authentication Server to be used is functional on your network. Referto your manufacturer's documentation for instructions to complete this task.There are 3 steps to the Network Authentication set up:1. Enable Network Authentication or Network Authentication with Guest Access.2. Configure the machine with the server details that you will use for authentication.3. For further instructions, go to the relevant page to select the server environment youwill be using to authenticate users.• Kerberos (Unix, Linux) on page 131• Kerberos (Windows ADS) on page 132• SMB (Windows NT 4) on page 133• SMB (Windows ADS) on page 132• LDAP (Lightweight Directory Application Protocol) on page 134• Xerox Secure Access (Chapter 16).Configure Network Authentication - Kerberos (Unix/Linux)1. At your Workstation, open the web browser, enter the TCP/IP Address of the machinein the Address bar.2. Press [Enter].3. Click on the [Properties] tab.4. Click on the [Security] link.5. Click on the [Authentication] link.6. Click on the [Authentication] link.7. Click on [Require Network Authentication].8. To allow guests to access the machine, select the [Allow Guest Access] option andenter the required [Passcode] for the guest account.NOTE: You cannot leave the Passcode blank.9. Click on [Kerberos (Unix, Linux)] under Authentication Type in the General area.10. Click on the [OK] button, if an alert message appears.11. Enter your Default Realm information in the [Required Information] area.12. Enter your Backup Realm information in the [Additional Information] area.13. If the [Alternates...] button is available, enter the details of additional alternaterealms the system should use for authentication.14. Click on [Always prompt for logoff after each Scan job], in the Logoff Reminderarea, if you want to enable this service.15. Click on the [Apply] button to accept the changes.If prompted, enter the Administrator’s User ID [admin] and Password [1111], andclick on [Login].
