4 Print Drivers46 Xerox WorkCentre 4250/4260 Series System Administration GuideConfigure your Print DriverInformation ChecklistBefore starting the Installation procedure, please ensure that the following items areavailable and/or the tasks have been performed:1. The appropriate printer driver should be installed on your Windows operating system.Procedure1. At your workstation, open your Printers folder.2. Right-click on the printer.3. Click on [Properties].4. Click on [Configuration].Bi-Directional Setup1. The driver can be set to automatically obtain information on the installed hardwareoptions and status of the device.2. Click on [Bi-Directional Setup].3. Click on [Automatic] to have the driver automatically configure the IP address of thedevice or click on [Manual] and enter the IP address or host name of the device.4. If you want to change the default SNMP settings, click on [SNMP CommunityName] and enter the required information.5. Click on the [OK] button.Installable Options1. If Bi-directional Setup is enabled, the driver will update with the options installed onthe device.2. If Bi-directional setup is not enabled, select the options that are installed on yourdevice.NOTE: LAN Fax requires the Embedded Fax feature to be installed.NOTE: Job Storage requires the Save Job for Reprint feature to be enabled.3. Click on the [OK] button.AccountingIf you have an Accounting feature such as Xerox Standard Accounting or NetworkAccounting installed, you can enable Accounting in the driver. For further information, seeChapter 12, Network Accounting on page 107.1. Click on the [OK] button to close your print driver Properties.