UnixXerox WorkCentre 4250/4260 Series System Administration Guide 31Linux LPRngStatic AddressingInformation ChecklistBefore starting the Installation procedure, please ensure that the following items areavailable and/or the tasks have been performed:1. See Chapter 3, Configure Static IPv4 Addressing using the Machine User Interface,Information Checklist on page 13.2. Linux operating system that supports PrintTool.NOTE: Not all distros of Linux support PrintTool.Procedure1. Follow the steps in Chapter 3, Configure Static IPv4 Addressing using the MachineUser Interface, Procedure on page 14 until step 38, then return to this page.Create the Print Queue1. Open the LPRngTool from the Linux Client.2. Click on the [Add].3. In the [Names] area, enter a name for your print queue.4. The spool directory is the directory where print jobs are stored and is a subdirectoryof [/var/spool/lpd]. Add the name of the print queue to the end of the subdirectorypath.5. In the [Hostname/IP of Printer] area, enter the hostname or IP Address of the Xeroxmachine.6. Click on [OK].7. Click on [Exit] to close the program.8. To allow access to the printer, edit the /etc/hosts table to list the client system.9. Edit and create the [/etc/hosts.lpd] file to list the client system.Dynamic AddressingInformation ChecklistSee Chapter 3, Configure Dynamic IPv4 Addressing using the Machine User Interface,Information Checklist on page 15.Procedure1. Follow the steps in Chapter 3, Configure Dynamic IPv4 Addressing using the MachineUser Interface, Procedure on page 16 until step 38, then return to this page.IMPORTANT: Click on [BOOTP] in step 9.
