Storing and Handling PaperXerox WorkCentre 7132 User Guide 213When not in use, the paper trays can be opened and paper can be loaded while themachine is running. However, do not open the active tray. This will cause the machineto stop the job being processed.Storing and Handling PaperAlways use high-quality, xerographic-grade paper in the machine. Damaged, curled, ordamp paper can cause jams and image quality problems. Follow these simple rules tostore paper.• Store paper in dry conditions, away from extreme heat or cold, such as radiators oropen windows.• Store paper flat on a shelf or pallet above floor level.• Leave the paper wrapped and boxed until ready to be used.• Re-wrap partly used packages of paper.NOTE: Paper should not be stored in the paper trays.Supported Paper Sizes and TypesThis section lists the sizes and types of paper that can be used with the machine.Supported Paper SizesThe following table lists the paper sizes supported for each paper tray, duplex moduleand the finisher.NOTE: For the capacity of each tray, refer to the Specifications chapter.Standard SizesNOTE: The standard sizes of paper that can be detected vary depending on the papersize table specified by the Key Operator. For information on setting the paper sizetable, refer to Paper Size Settings in the Setups chapter on page 234.#PaperSizeDimensions(mm)LEF/SEFTray 1/Tray 2, 3(Two TrayModule)Tray 2, 3(TTM)Tray 5(Bypass)DuplexModuleOfficeFinisherIntegratedOfficeFinisherA6 105.0 148.0 LEF X X XA5 148.0 210.0 SEF O X O O X OLEF X X X OA4 210.0 297.0 SEF O X O O OLEF O O O O OA3 297.0 420.0 SEF O X O O O
