Job AssemblyXerox WorkCentre 7132 User Guide 81• Chapter Start - Automaticallysplits each batch of originals intochapters, starting on a new page.Using the [Multiple-Up - NewPage] option sets whether to printthe first page in each stack oforiginals on a new page or on the same page as the previous original when theMultiple-Up feature is selected.• Separators - Automatically splitseach batch of originals intochapters with a separator pagebetween each chapter. Select[Separators], and specify the traycontaining the blank pageseparators. Four presets, including the bypass tray, are available, depending onyour machine configuration. For more information on the bypass tray, refer to [Tray5 (Bypass)] Screen on page 53.Change SettingsAllows you to change the settings on the [Copy] screen before scanning the nextsection. Press the button on the control panel to start scanning.CancelCancels the build job process.StartStarts scanning the next section.Sample SetThis feature allows you to print one set of the job to check the output is correct, prior toprinting the entire job. You can choose whether or not to print more sets after checkingthe print result.1. Select [Sample Set] on the [JobAssembly] screen.2. Select the required option.3. Select [Save].OffDisables the feature.OnEnables the feature. After copying one set, the job is suspended. Select [Start] to copythe remaining sets or [Stop] to stop the job.NOTE: Copies produced by [Sample Set] are counted towards the total copy count.
