Common SettingsXerox WorkCentre 7132 User Guide 223Audio TonesThis feature allows you to select the volume level of tones to be generated at variousoccasions. You can choose different volume levels for each item shown on the screen.1. Select [Audio Tones] on the[Common Settings] screen.2. Change the required settings.Use the side tabs to switchbetween screens.3. Select [Close].Control Panel Select ToneSpecifies the volume level of the tone generated when an appropriate button on thecontrol panel is pressed and its action is accepted.Control Panel Alert ToneSpecifies the volume level of the tone generated when an inappropriate button on thecontrol panel is pressed.Machine Ready ToneSpecifies the volume level of the tone generated when the machine becomes ready tocopy or print, for example, after the power is switched on.Copy Job Complete ToneSpecifies the volume level of the tone generated when copying finishes successfully.Non-Copy Job Complete ToneSpecifies the volume level of the tone generated when a job other than copying finishessuccessfully.Fault ToneSpecifies the volume level of the tone generated when a job did not finish properly.Alert ToneSpecifies the volume level of the tone generated when a job is suspended due to anerror.Out of Paper Warning ToneSpecifies the volume level of the tone generated when the machine runs out of paper.Low Toner Alert ToneSpecifies the volume level of the tone generated when it is time to replace the tonercartridge.
