Step Display/Result7. Press and scroll to A1-02.← →-PRMSET- PRGControl MethodFWDA1-02= 0 0V/f Control8. Press to display the value set to A1-02. If the first “0” blinks, parameter settings are unlocked.← →-PRMSET- PRGControl MethodFWDA1-02= 0V/f Control09. Use and to change the value if desired (though changing the control mode at this point isnot typically done). ← →-PRMSET- PRGControl MethodFWDA1-02= 0PM OpenLoop Vect510. Press to save the setting, or press to return to the previous display without saving changes. Entry Accepted11. The display automatically returns to the parameter display.-PRMSET-InitializationSelect LanguagePRGA1-00= 0← →FWDNote: 1. Parameter settings can be edited after entering the correct password.2. Performing a 2-Wire or 3-Wire initialization resets the password to “0000”.n A1-06: Application PresetSeveral Application Presets are available to facilitate drive setup for commonly used applications. Selecting one of theseApplication Presets automatically assigns functions to the input and output terminals and sets a predefined group of parametersto values appropriate for the selected application.In addition, the parameters most likely to be changed are assigned to the group of User Parameters, A2-01 through A2-16.User Parameters are part of the Setup Group, which provides quicker access by eliminating the need to scroll through multiplemenus.u A2: User Parametersn A2-01 to A2-32: User Parameters 1 to 32The user can select up to 32 parameters and assign them to parameters A2-01 through A2-32 to provide quicker access byeliminating the need to scroll through multiple menus. The User Parameter list can also save the most recently editedparameters.No. Parameter Name Setting Range DefaultA2-01 to A2-32 User Parameters 1 to 32 A1-00 to S6-07 Determined byA1-06 <1> <2><1> This setting is the default setting of the Setup Mode parameters. Refer to TOEPC71063610 User Manual Section 4 for details.<2> A1-06 determines how the setting of user parameters A2-01 through A2-32 are changed.Saving User ParametersTo save specific parameters to A2-01 through A2-32, set parameter A1-01 to 2 to allow access to all parameters, then enterthe parameter number to one of the A2-oo parameters to assign it to the list of User Parameters. Finally, set A1-01 to 1 torestrict access so users can only set and refer to the parameters saved as User Parameters.1.1 A: Initialization22 YASKAWA SIEP YAIZ1U 03B YASKAWA AC Drive – Z1000 Programming Manual
