114 CHAPTER 6: CONFIGURING DEPLOYMENT MODES11 Enter the authentication password used by the routers in the Passwordfield. Enter it again in the Confirm field. The password must be 8characters or less and is case-sensitive. Click Next.12 The Finish screen is displayed. Carefully read the summary information,which displays the WCCP version, Router IP Addresses or MulticastAddress and whether WCCP Password Authentication is enabled ordisabled. Click Finish.You should repeat this configuration process for each additionalWebcache that you want to include in the service group.If the Webcache is deployed in WCCP mode, you must use port 8081 toaccess the Webcache’s Web interface e.g. http://192.168.1.253:8081. Ifyou use port 80, you may experience problems accessing the Webinterface.For further information about configuring the Cisco routers for WCCPusing the Cisco Command Line Interface, see the “Default Settings forthe Webcache” appendix on page 307.For further information, see “WCCP Version 2” on page 43.Configuring ProxyRelay with theSuperStack 3FirewallTo configure Proxy Relay mode using the Web interface of the Webcache:1 Install the Webcache as described in Chapter 2 “Installing theWebcache”, taking into account any safety information.a Connect the Webcache to the DMZ port of the Firewall. Use the LANport of the Webcache for this connection.Network Address Translation (NAT) does not apply to the DMZ port of theFirewall so you will need to configure the Webcache with a registered IPaddress.b Set the Webcache to Proxy Mode. This setting can be made from theGetting Started Wizard or by selecting Caching > Set Caching Modefrom the Web interface.c In the Proxy Mode Ports field enter the number 8080. This is thedefault proxy relay TCP port number. You can enter a different TCPport number if you wish.dua1611-5aaa04.book Page 114 Friday, November 29, 2002 8:56 PM
