276 CHAPTER 19: P ROBLEM S OLVINGAccessing theWebcache via theConsole LineThe terminal or terminal emulator cannot access the Webcache.Check that: Your terminal or terminal emulator is correctly configured to operateas a generic (TTY) terminal, or a VT100 terminal. You have performed the Command Line Interface wake-up procedureby pressing [Return] a few times. The settings on your terminal or terminal emulator are correct andmatch those set for the Webcache console port: 8 data bits no parity 1 stop bit 9600 baud (default)The Webcache only works with line speeds from 1200 to 19,200baud. The default line speed of the Webcache is 9600 baud.If the login sequence still does not display, reset the Webcache. Forfurther information, see “Rebooting the Webcache” on page 268. If thisdoes not work, initialize the Webcache. For further information, see“Initializing the Webcache” on page 267.Accessing theWebcache viaTelnetYou cannot access the Webcache using Telnet.Check that: The network cables are secure. The network cable used to access the Webcache is connected to theLAN port. The Port Activity LED on the Webcache LAN port is Green or GreenFlashing. The duplex settings are as expected by the rest of your network. You can ping the Webcache. The terminal or terminal emulator is set to VT52 or VT100 mode. Press Return a few times to wake up the CLI.The terminal or terminal emulator can no longer access theWebcache over the network.dua1611-5aaa04.book Page 276 Friday, November 29, 2002 8:56 PM