256 CHAPTER 18: C OMMAND L INE I NTERFACEThe following prompt is displayed:Enter the mode of operation (proxy, transparent, inline)[transparent]:21 Enter either proxy, transparent or inline.For further information, see “Deploying the Webcache in Your Network”on page 70.If you entered proxy, the following prompt is displayed:Enter the port number [8080]:22 Enter the port number on which the Webcache will listen for traffic.The Finish prompt is displayed, which summarises the selections that youhave made.Exiting theCommand LineInterfaceYou can exit the Command Line Interface at any time using the logoutcommand on the Top-level menu.To exit the Command Line Interface, at the Top-level menu, enter:logoutIf a period of inactivity lasts longer than 30 minutes, the Webcache willautomatically log you out.After the exit, the first key that you press returns you to the loginsequence.Displaying andChanging WAN andLAN PortInformationYou can display and change the WAN and LAN port information for theWebcache using the commands on the Physical Interface menu. Thesecommands allow you to: Configure the WAN and LAN Ports Display WAN and LAN Port InformationConfiguring the WANand LAN PortsYou can use the portMode command on the PhysicalInterface menu toconfigure the WAN and LAN port settings of the Webcache. Thiscommand allows you to configure the autonegotiation setting, link speedand duplex state for each port.dua1611-5aaa04.book Page 256 Friday, November 29, 2002 8:56 PM
