252 CHAPTER 18: C OMMAND L INE I NTERFACEA Quick Guide tothe CommandsTable 10 describes the commands that are available in the Command LineInterface.Table 10 Command Line Interface commandsCommand What does it do?gettingStarted Specifies basic setup information for the Webcache.logout Exits the current user from the Command Line Interface.physicalInterface portMode Sets the mode of operation of the WAN and LAN ports.physicalInterface summary Displays summary information for the WAN and LAN ports.protocol basicConfig Specifies IP and Domain Name System (DNS) configuration.protocol dnsConfig Specifies Domain Name System (DNS) configuration.protocol initializeConfig Resets IP information to factory default settings.protocol ipConfig Specifies IP management configuration.protocol ping Pings other devices on your network.protocol summary Displays IP summary information.protocol traceRoute Traces the network hops to devices on your network.security management Secures the management interfaces of the Webcache.security password Specifies the password for the current user.security pwdRecover Enables and disables password recovery.system control initialize Initializes the Webcache to factory default settings.system control reboot Reboots the Webcache.system management community Sets the SNMP community string.system management contact Specifies a contact name for the Webcache.system management location Specifies location details for the Webcache.system management name Specifies a name for the Webcache.system summary Displays summary information for the Webcache.dua1611-5aaa04.book Page 252 Friday, November 29, 2002 8:56 PM