| 
3-2Adaptec SCSI Card 39320D User’s Guide for Floppy Disks (OEM)The default settings are appropriate for most systems and shouldnot be changed. Run SCSISelect if you need to change or viewcurrent settings, or if you need to use the SCSI disk utilities. See thedescriptions of each option, starting on page 3-4.SCSISelect Options Available Settings Default SettingSCSI Bus Interface Definitions:SCSI Controller ID 0-15 7SCSI Controller Parity EnabledDisabledEnabledSCSI Controller Termination:Ch. ACh. BAutomatic,Enabled, DisabledAutomatic,Enabled, DisabledAutomaticAutomaticBoot Device Configuration Options—BBS Systems Only:Select Master SCSI Controller A, B ABoot Device Configuration—Non-BBS Ssystems Only:Select Master SCSI Controller A, B ABoot SCSI ID [Auto-sync] 0-15 0Boot LUN Number1 [Auto-sync] 0-7 0SCSI Device Configuration Options:Sync Transfer Rate (MB/sec) 320, 160, 80.0, 66.6,40.0, 33.3, 20.0,10.0, ASYN320Packetized Yes, No Yes (Enabled)QAS Yes, No Yes (Enabled)Initiate Wide Negotiation Yes, No Yes (Enabled)Enable Disconnection Yes, No Yes (Enabled)Send Start Unit Command Yes, No Yes (Enabled)BIOS Multiple LUN Support 1 Yes, No No (Disabled)Include in BIOS Scan 2 Yes, No Yes (Enabled)Advanced Configuration:Reset SCSI Bus at IC Initialization Enabled, Disabled EnabledDisplay Messages duringBIOS Initialization [Auto-sync]Enabled, Disabled EnabledExtended INT 13 Translation forDOS Drives > 1 GByteEnabled, Disabled Enabled |
