Configuration: Call BackupLocal Management User’s Guide2-41Configure the D ChannelUse the following command in Network Tools to set the switch type:setswitchtype [WANPORTNUM] [SWITCHTYPE]WANPORTNUM — If the HSIM or CyberSWITCH occupies WAN port number one, use 1, if itoccupies port number two, use 2 as the WANPORTNUM.SWITCHTYPE — Choose between the types of ISDN BRI switches. The choices are NI1 (defaultfor BRI), DMS100 (BRI/PRI), ATT5 ESS (BRI/PRI, default for PRI), ATT-4ESS (PRI) andNET3 (BRI).Set Phone Numbers and SPIDs for the PortThe following Network Tools command is used to set the phone numbers and the SPIDs (ifapplicable):setisdnbri [WANPORTNUM] [LDN1][SPID1] [LDN2] [SPID2]LDN1 — The first Local Directory Number. Likewise, LDN2 is the second Local DirectoryNumber.SPID1 — The first Service Profile Identifier. Likewise, SPID2 is the second Service ProfileIdentifier.SPID format: [XXXYYYZZZZ] [01] [01]Where XXX represents the area code, YYY represents the prefix, and ZZZZ represents the localnumber. [01] [01] is the fixed suffix. This is the proposed generic SPID format.Example 1: For the first WAN port to be configured for ISDN, issue the command:setisdnbri 1 5551000 0555100001 5553000 0555300001For the second WAN port to be configured, issue the command:setisdnbri 2 5551000 0555100001 5553000 0555300001The command also allows for skipping or clearing any entry by using the key letters S (or s) to skipthe field, and C (or c) to clear the field.Example 2: To skip LDN1 and SPID1, change LDN2, and clear SPID 2, issue the followingcommand:setisdnbri 2 s s 0555600001 c
