Other CommandsLocal Management User’s Guide3-25fr:Syntax: frDescription: The fr command provides status related to Frame Relay and its ControlProtocols. This allows you to monitor DLCIs and aids troubleshooting.• MGR: This is the physical WPIM for the DLCI• CKT: This is the virtual port number for the DLCI• IF: This is the MIB II interface number for the DLCI• DLCI: This is the circuit DLCI number• DCP: This is the state of FR Data Compression on this DLCI (on/off)• STATE: This is the DLCI circuit state (active/invalid/inactive)• Inactive Reason: This value is empty for active/invalid states. It isfilled in if the circuit is inactive. It has the following values:a. t391 Polling Error: This is a result of a failure in theSynchronous polling between us and the FR switch. If 3 out ofany 4 polling cycles fail then both will place the link between usand the FR switch in a “link down” state. This will cause allDLCIs to be set to inactive, and no data placed on the wire (otherthan polling messages) until the service affecting condition iscleared. This service affecting condition can be the result of anumber of things:- Our STATUS ENQUIRY message never reaches the FRswitch, due to: our WAN driver, or our physical WANconnection to the Fr switch dropping the packet for somereason.- The STATUS RESPONSE message never reaches the FRprotocol code, due to: our WAN driver, or our physical WANconnection to the Fr switch, or the FR switch itself droppingthe packet for some reason.- The incorrect LMI type Si selected at our side or the Frswitch side. If they do not match, then polling errors willresult.
