Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

WPIM-DI ConfigurationLocal Management User’s GuideC-73. Use the arrow keys to highlight NI/DI Timeslot View. Press the SPACE bar to select New, thenpress ENTER. The cursor moves to Timeslot #1 of the Timeslot Configuration table.4. Insert an interface number (refer to the NOTE on page C-7) into every Timeslot. Type thenumber, press ENTER, then use the arrow keys to highlight the next timeslot field. Exit thisfield by using the arrow keys. The cursor automatically moves to the NI/DI Line Coding field.5. Use the arrow keys to highlight NI/DI Line Coding. Press the SPACE bar to select B8ZS orAMI.6. Use the arrow keys to highlight NI/DI Frame Type. Press the SPACE bar to select ESF or D4.7. Use the arrow keys to highlight NI Tx Clock Source. Press the SPACE bar to select LocalTiming (no clock source provided by telephone company) or Loop Timing (clock sourceprovided by telephone company).8. Use the arrow keys to highlight NI/DI Line Buildout (LBO). Press the SPACE bar to select 0db unless the service provider recommends another setting.9. Use the arrow keys to highlight NI/DI Loop-back. Press the SPACE bar to select None.NOTESThe value assigned to the timeslots is the interface being used for WAN communication.The available interface range is displayed on the WAN Physical Configuration screen(see Figure C-1). You may insert any of the available interface numbers into thetimeslots.Any timeslots that are given a value of 000 are either not used (DI Enabled set to Off) orare mapped to another WAN module (e.g., WPIM-T1) that is connected to the DIinterface (DI Enabled set to On).When DI Enabled is set to diDataEnable, the timeslot view changes to view data fromDI. Host data passes through the DI interface and slots that are marked DI are mappedto the NI interface.The following four steps are based on information supplied by the service provider.Consult the service provider for the correct settings.NOTEIf you are using a Local clock source, set only one end of the circuit for Local Timing, theother end must be set for Loop Timing.