Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

Appendix B: WPIM-E1 ConfigurationB-6Local Management User’s GuideThe line configuration information shown in Table B-1 must be supplied by the service provider.WPIM-E1 Physical ConfigurationBegin the WPIM-E1 configuration by accessing the WAN Physical Configuration screen throughLocal Management (Figure B-1). Proceed with the following steps:1. Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press theSPACEBAR to select the WPIM being configured, then press ENTER.2. Use the arrow keys to highlight the MgrType. Press the SPACE bar to select PPP, then pressENTER.3. Use the arrow keys to highlight Timeslot View. Press the SPACEBAR to select New, thenpress ENTER. The cursor moves to Timeslot #2 of the Timeslot Configuration Table.4. Insert an interface number (see NOTE below) into every timeslot. Type the number, pressENTER, then use the arrow keys to highlight the next timeslot field. Exit this field by using thearrow keys. The cursor automatically moves to the E1 Line Coding field.5. Use the arrow keys to highlight E1 Line Coding. Press the SPACEBAR to select HDB3 orAMI.6. Use the arrow keys to highlight E1 Frame Type. Press the SPACEBAR to select E1 orE1-CRC.Table B-1 Telco Configuration InformationConfiguration Information Required By User Configuration InformationSupplied By Service ProviderLine Coding HDB3 or AMIFrame Type E1 or E1-CRCClock Source Loop Timing or Local TimingNOTEThe value assigned to the timeslots is the interface being used for WANcommunication. The next available interface is displayed on the WAN PhysicalConfiguration screen (see Figure B-1).The following three steps are based on information supplied by the service provider.Consult the service provider for the correct settings.