Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

NoticeiiLocal Management User’s GuideINDUSTRY CANADA NOTICEThis digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the RadioInterference Regulations of the Canadian Department of Communications.Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de laclass A prescrites dans le Règlement sur le brouillage radioélectrique édicté par le ministère des Communications du Canada.NOTICE: The Industry Canada label identifies certified equipment. This certification means that the equipment meetstelecommunications network protective, operational and safety requirements as prescribed in the appropriate Terminal EquipmentTechnical Requirements documents (s). The department does not guarantee the equipment will operate to the user’s satisfaction.Before installing this equipment, users should ensure that it is permissible to be connected to the facilities of the localtelecommunications company. The equipment must also be installed using an acceptable method of connection. The customer should beaware that compliance with the above conditions may not prevent degradation of service in some situations.Repairs to certified equipment should be coordinated by a representative designated by the supplier. Any repairs or alterations made bythe user to this equipment, or equipment malfunctions, may give the telecommunications company cause to request the user todisconnect the equipment.Users should ensure for their own protection that the electrical ground connections of the power utility, telephone lines and internalmetallic water pipe system, if present, are connected together. This precaution may be particularly important in rural areas. Caution:Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, orelectrician, as appropriate.NOTICE: The Ringer Equivalence Number (REN) assigned to each terminal device provides an indication of the maximum number ofterminals allowed to be connected to a telephone interface. The termination on an interface may consist of any combination of devicessubject only to the requirement that the sum of the ringer equivalence Numbers of all the devices does not exceed 5.VCCI NOTICEThis is a Class A product based on the standard of the Voluntary Control Council for Interference by Information TechnologyEquipment (VCCI). If this equipment is used in a domestic environment, radio disturbance may arise. When such trouble occurs, theuser may be required to take corrective actions.