Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

Local Management1-20Local Management User’s Guide2. Enter the IP address of the Default Gateway using DDN format.For example: 168.192.79.1213. Press ENTER. If the Default Gateway address entered was a valid format, the cursor returns tothe beginning of the Default Gateway field. If the entry was not valid, the Event Message fielddisplays “INVALID DEFAULT GATEWAY OR FORMAT ENTERED”. Local Managementdoes not alter the current value and refreshes the Default Gateway field with the previous value.4. Use the arrow keys to highlight the SAVE command field.5. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.Setting the Default InterfaceTo set the default interface, perform the following steps:1. Use the arrow keys to highlight the Default Interface field.2. Enter the interface number for the Default Gateway in this field.3. Press ENTER. If the interface entered was a valid format, the cursor returns to the beginning ofthe Subnet Mask field. If the entry was not valid, the Event Message field displays“PERMISSIBLE RANGE: 1...X”. Local Management does not alter the current value andrefreshes the Default Interface field with the previous value.4. Use the arrow keys to highlight the SAVE command field.5. Press ENTER. The Event Message field at the top of the screen displays “SAVED OK”.NOTEThe default gateway is intended for bridging only mode. For routing use a default routeentry in your routing table.NOTEBoth the default gateway and default interface must be changed or an error results. Toreturn to the default state, select NONE DEFINED for both the default gateway anddefault interface selections.The default gateway is intended for bridging only mode. For routing use a default routeentry in your routing table.