Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

Appendix C: WPIM-DI ConfigurationC-6Local Management User’s GuideWPIM-DI ConfigurationThis section provides step-by-step instructions for configuring the WPIM-DI to use a full orfractional T-1 circuit in a PPP or Frame Relay environment. This simplified example assumes thesetup shown in Figure C-5 using two host platforms containing a WPIM-DI at Site #1 and aWPIM-T1 at Site #2. Configurations may vary depending on the host platform.Figure C-5 Full T-1 ConfigurationThe line configuration information shown in Table C-1 must be supplied by the service provider.WPIM-DI Physical ConfigurationBegin the configuration by accessing the WAN Physical Configuration screen (Figure C-1)through Local Management. Proceed with the following steps:1. Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press the SPACEbar to select the WPIM being configured, then press ENTER.2. Use the arrow keys to highlight the MgrType field. Press the SPACE bar to choose the desiredProtocol Manager.Table C-1 Telco Configuration InformationConfiguration InformationRequired by UserConfiguration InformationSupplied by Service ProviderLine Coding B8ZS or AMIFrame Type ESF or D4Clock Source Loop Timing or Local TimingDS0 (Timeslots) Timeslots being used for each end ofthe circuitSITE #1 Telco Cloud24 Timeslots24 TimeslotsSITE #21482_05