Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

Configuration: Frame RelayLocal Management User’s Guide2-27Point To Point Mode (LM WAN Interface Configuration)The difference in configuration between PtoP and PtoMP is that DLCIs are not learneddynamically. DLCI information must be entered in statically, even if in an LMI mode. All the otherinformation in FR PtoMP configuration is applicable.Since in Point To Point mode the DLCI is static, it will not be deleted if the switch sends noinformation on the DLCI, but must be deleted manually through LM or SNMP, nor will DLCIs beadded dynamically. The state will reflect the correct value that the FR DCE Switch reports, andstatic circuits will go “Invalid” if there is a physical connection problem.5. Use the arrow keys to highlight Timeslot View. Press the SPACE bar to select New, then pressENTER. The cursor moves to the first timeslot available in the Timeslot Configuration Table.6. Insert the interface number (refer to NOTE below) into the timeslot being used. Type thenumber, press ENTER, then exit this field by using the arrow keys. The cursor automaticallymoves to the T1 Line Coding field.The next four steps are based on information supplied by the service provider. Consult the serviceprovider for the correct settings.7. Use the arrow keys to highlight T1 Line Coding. Press the SPACE bar to select B8ZS or AMI,then press ENTER.8. Use the arrow keys to highlight T1 Frame Type. Press the SPACE bar to select ESF or D4,then press ENTER.9. Use the arrow keys to highlight T1 Tx Clock Source. Press the SPACE bar to select Local (noclock source provided by telephone company) or Loop (clock source provided by telephonecompany), then press ENTER.NOTEWhen changing from one protocol to another on a HSIM or CyberSWITCH that hasbeen operational, save NONE as the protocol before changing to another protocol.The previous version of firmware allowed multiple Frame Relay Protocols running ondifferent T1 or E1 channel groups. This is no longer possible. Therefore, only oneFrame Relay Protocol can be configured per physical interface.NOTEThe value assigned to the timeslots is the interface being used for WANcommunication. Only one interface can be assigned to the timeslot when runningFrame Relay.