Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

FRAME RELAY CONFIGURATIONLocal Management User’s GuideB-11The following information must be supplied to the service provider.• LMI type: Q.933-AThe line configuration information shown in Table B-3 must be supplied by the service provider.WPIM-E1 Physical ConfigurationBegin the WPIM-E1 configuration by accessing the WAN Physical Configuration screen throughLocal Management (Figure B-1). Proceed with the following steps:1. Use the arrow keys to highlight the [WPIM] field at the bottom of the screen. Press theSPACEBAR to select the WPIM being configured, then press ENTER.2. Use the arrow keys to highlight the MgrType. Select either FR Pto MP (Frame Relay Point toMultipoint) or FR PtoP (Frame Relay Point to Point) using the SPACE bar.3. Use the arrow keys to highlight Timeslot View. Press the SPACEBAR to select New, thenpress ENTER. The cursor moves to Timeslot #2 of the Timeslot Configuration Table.4. Insert an interface number (see NOTE on page B-6) into every timeslot being used. Type thenumber, press ENTER, then use the arrow keys to highlight the next timeslot field. Exit thisfield by using the arrow keys. The cursor automatically moves to the E1 Line Coding field.5. Use the arrow keys to highlight E1 Line Coding. Press the SPACEBAR to select HDB3 orAMI.6. Use the arrow keys to highlight E1 Frame Type. Press the SPACEBAR to select E1 orE1-CRC.7. Use the arrow keys to highlight E1 Tx Clock Source. Press the SPACEBAR to select Local(no clock source provided by telephone company) or Loop (clock source provided by telephonecompany).Table B-3 Telco Configuration InformationConfiguration Information Required ByCustomer Information Supplied By Service ProviderLine Coding HDB3 or AMIFrame Type E1 or E1-CRCClock Source Loop Timing or Local TimingDSO’s (Timeslots) Timeslots being used for each end of the circuit