Cabletron Systems CyberSWITCH CSX400 User Manual

Also see for CyberSWITCH HSIM-W6: Setup guide Configuration guide User guide Installation guide

Contents

PPP CONFIGURATIONLocal Management User’s GuideA-56. Use the arrow keys to highlight FORCE RTS True. Press the SPACE bar to set to ENABLE.7. Use the arrow keys to highlight FORCE DTR True. Press the SPACE bar to set to ENABLE.8. Use the arrow keys to highlight the SAVE command. Then press ENTER. The message “SaveDone!” displays and Local Management saves the changes to memory and the device reboots.Local Management must be reaccessed before any other configurations may be made.9. Proceed to the next section for the WPIM-SY Interface Configuration.WPIM-SY Interface ConfigurationThis screen is accessed through the WAN Physical Configuration screen. Refer to Figure A-2 andproceed with the following steps to configure the WAN Interface through Local Management.1. Access the WAN Interface Configuration screen by using the arrow keys to highlight the WANInt Config option, then press ENTER.2. Use the arrow keys to highlight Interface Number. Set the WAN connection Interface Numberby typing the same number found in the Interfaces field on the WAN Physical Configurationscreen into the Interface Number field, or use the SPACE bar to toggle to the correct InterfaceNumber, then press ENTER.3. Use the arrow keys to highlight ECP Enable. Press the SPACEBAR to select On to enableencryption.4. Use the arrow keys to highlight CCP Enable. Press the SPACEBAR to select On to enablecompression.5. Make any other changes as desired.6. Use the arrow keys to highlight the SAVE command. Press ENTER. The message “SaveDone!” displays and Local Management saves the changes to memory.The WAN configuration is complete. It takes up to 60 seconds for the WAN Interface to come outof standby and for communications to begin.NOTESet FORCE CTS and FORCE DSR to YES only if the CSU/DSU does not supportthese flow control terms.