IP Configuration ScreenLocal Management User’s Guide1-35Version — Displays the IP Routing version number used on the HSIM or CyberSWITCH.AdminStatusTime — Displays the amount of time elapsed since an IP address was assigned tothe HSIM or CyberSWITCH.UDP Type — Displays the User Datagram Protocol (UDP) Service to which the selected UDPPort number corresponds.Description — Describes the selected Port.MAC Address — Displays the physical (MAC) address of the HSIM or CyberSWITCH.Interf. Type — Displays the type of interface used by the specified port.Oper Status — Displays the operational status of the selected port.IP General Configuration FieldsThis section provides a general overview of the procedures required to configure the HSIM orCyberSWITCH. The following describes each of the modifiable IP General Config Screen fields.+PORT- — Use this field to select the routing port you wish to configure.+REDIRECTOR- — Use this field to toggle through a list of commonly used UDP port numbers.UDP port numbers are associated with the relay agent functionality of the router.UDP Port — User Datagram Protocol (UDP) Port affected.Framing — Use this field to select the format of the frame in which IP packets are encapsulatedfor transmission.MTU — Use this field to set the Maximum Transmission Unit (MTU).IP Routing — Use this field to enable IP Routing Services.IP Forwarding — Use this field to enable IP Forwarding.Proxy ARP — Use this field to enable Proxy Address Resolution Protocol (ARP).Address — Use this field to assign an IP address to the port that you wish to configure.Mask — Use this field to set the Subnet Mask for the port that you wish to configure.
