Initial Default. LC LogFilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetFALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSECMC8503Message Unable to access the IPv4 information of the server.DetailedDescriptionCMC is unable to access the IPv4 information for the specified server. Unable to display thespecified servers Launch iDRAC link on the CMC Web interface.RecommendedResponse ActionEnable IPv4 on the specified slots iDRAC via the CMC command line or Web GUI interface, forthe iDRACs launch point to show up on the CMC web GUI. For the command line options ornavigation for Web intereface, see the Trobleshooting section in the CMC Users Guide.Category System HealthSubCategory CMC = Chassis Management ControllerSeverity Severity 1 (Critical)Trap/EventID FALSELCD Message No LCD message display defined.Initial Default. LC LogFilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetFALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSECMC8504Message Unable to access server:arg1, because the NIC is disabled on the identified server.Arguments •arg1 = slot numberDetailedDescriptionThe NIC is disabled on the server identified in the message, and the CMC is unable to displaythe link to launch the iDRAC web interface.RecommendedResponse ActionEnable the NIC on the server identified in the message using the CMC command line or CMCWeb interface, so that the link to launch iDRAC is displayed on the CMC Web interface. Toenable the NIC for DHCP using RACADM, enter "racadm setniccfg -m server- -d"where is the server identifed in the message. To enable the NIC using the Webinterface, click Server Overview > select the identified server, go to Setup > select the EnableLAN check box.Category System HealthSubCategory CMC = Chassis Management ControllerSeverity Severity 3 (Informational)106
