Severity Severity 2 (Warning)Trap/EventID FALSELCD Message No LCD message display defined.Initial Default. LC LogFilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetFALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSEPSU8503Message The PSU in slotarg1detected 220 VAC input voltage and does not match chassis configuration.Arguments •arg1 = slot numberDetailedDescriptionThe input voltage of the PSU specified in the message does not match the input voltage of thePSUs already present in the chassis.RecommendedResponse ActionDo the following: 1) Check if the input voltage of all the PSUs are the same. 2) If the inputvoltage of the PSU specified in the message is not the same, then remove the unmatched PSU.Category AuditSubCategory PSU = Power SupplySeverity Severity 2 (Warning)Trap/EventID FALSELCD Message No LCD message display defined.Initial Default. LC LogFilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetFALSE FALSE FALSE FALSE TRUE FALSE FALSE FALSE FALSEPSU8504Message The Allow 110 VAC Operation overload risk is not acknowledged.DetailedDescriptionSelecting the Allow 110 VAC Operation involves potential risk that an overload can occur. Theoverload risk was not acknowledged in the CMC Web interface when the selection was made.RecommendedResponse ActionSelect the Allow 110 VAC Operation and accept the subsequent dialog that acknowledges theoverload risk.Category AuditSubCategory PSU = Power SupplySeverity Severity 3 (Informational)510
