FilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetTRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSECTL57Message The factory default settings were restored onarg1.Arguments •arg1 = controller NameDetailedDescriptionThe controller was reset to factory default configuration settings.RecommendedResponse ActionNo response action is required.Category StorageSubCategory CTL = Storage ContrSeverity Severity 3 (Informational)Trap/EventID 4331LCD Message No LCD message display defined.Initial Default. SNMP Alert;#LCD;#Remote System LogFilterVisibility IPMI Alert SNMPAlert EmailAlert LC Log LCD Power Off PowerCycle ResetTRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSECTL58Messagearg1SAS SMP communications errorarg2Arguments •arg1 = Controller name•arg2 = argsDetailedDescriptionThe text for this alert is generated by the firmware and can vary depending on the situation.The reference to SMP in this text refers to SAS Management Protocol.RecommendedResponse ActionThere may be a SAS topology error. See the hardware documentation for information oncorrect SAS topology configurations. There may be problems with the cables such as a looseconnection or an invalid cabling configuration. See the Cables Attached Correctly section formore information on checking the cables. See the hardware documentation for information oncorrect cabling configurations. Verify that the firmware version is supported.Category StorageSubCategory CTL = Storage ContrSeverity Severity 1 (Critical)190
