USING THE CLP INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−200892Showing Outlet InformationThe show command displays the name, power state (on or off), and associatedsensors for one outlet or for all outlets.SyntaxThe following is the syntax for the show command:clp:/−> show /system1/outlet number>where is the number of the outlet. To display information for alloutlets, type the wild card asterisk (*) instead of a number.AttributesYou can use the name and powerState attributes to filter the output of the showcommand. The name attribute displays only the name of the outlet, and thepowerState attribute displays only the power state (on or off).The following shows the syntax for both attributes:clp:/−> show –d properties=name /system1/outlet number>clp:/−> show –d properties=powerState/system1/outlet number>where is the number of the outlet. In both cases, the outlet numbercan also be a wild card asterisk (*).ExamplesFigure 95 shows an example of the output when a show command is entered withoutattributes.Figure 95. Example 1 – No Attributes
