USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−2008 633. Select the threshold from the second list under Event (see Figure 58). The list ofthresholds vary depending on what was selected in the first list.Figure 58. Thresholds4. Select an direction from the Event Direction list. If set to Assert, this alert will only trigger when a measured value moves pasta critical threshold (either above an upper critical threshold, or below a lowercritical one). If set to Deassert, this alert will only trigger when a measured value returns tonormal from a critical state (either below an upper noncritical threshold, orabove a lower non]critical one). If set to Assert & Deassert, this alert will trigger when a measured valuecrosses any threshold state.5. Select a policy from the Policy list.6. Click Add. The alert is added to the system.NOTE No policies display in this drop−down list until you create them. See Creating Alert Policies" belowfor instructions.NOTE If an Environmental Temperature or Humidity sensor is selected, an event will be created for eachlogical Temperature or Humidity sensor. These event alerts can be deleted so that only the ones you want arepresent.Creating Alert PoliciesAlert policies allow you to associate events with destinations. Policies determinewhether specific events trigger an entry in the event log, an email message to anadministrator, an SNMP trap, a selected outlet to be switched on/off/cycled, or anycombination of the four.