USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−2008 43Enabling Group−based Access Control RulesTo enable group−based access control rules:1. Select Device Settings, and then select Security. The Security Settings pagedisplays. The panel labeled Group Based System Access Control controls thisfeature. See Figure 42.Figure 42. Group Based System Access Control Panel (Enabled)2. Select the Enable Group Based System Access Control check box. This enables thefeature.3. Click Apply. Group−based access control rules are enabled.Changing the Default ActionThe default action is shown in the Group Based System Access Control panel on theSecurity Settings page. To change the default action:1. Select Device Settings, and then select Security. The Security Settings pagedisplays. The panel labeled Group based System Access Control controls thisfeature.2. Select the Enable Group based System Access Control check box if it is not alreadyselected.3. Select the action you want from the Default Action list in the (see Figure 42).4. Click Apply. The default action is applied.