USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−2008 77Modifying the Communications, Port, and Bandwidth SettingsYou can use Telnet or SSH to log into the ePDU CLP interface. However, by default,SSH is enabled and Telnet is not (because it communicates in the clear and istherefore not secure). You can change this and enable or disable either application.You can also set a bandwidth limit, and change any of the default port settings.Finally, you can enable or disable the Eaton Setup Protocol.To do this:1. Select Device Settings, and then select Network. The Network Settings pagedisplays. The Miscellaneous Network Settings panel on the top right contains thecommunications, port, and bandwidth settings. See Figure 74.Figure 74. Miscellaneous Network Settings Panel2. By default, CLP−Telnet is disabled and CLP−SSH is enabled. To change this, selecteither check box.3. To set an upper limit on the amount of bandwidth allowed for Telnet or SSH,type the number of kilobits per second in the Bandwidth Limit field.4. By default, the HTTP, HTTPS, Telnet, and SSH ports are set to the standard portsfor these communications protocols. If you prefer to use different ports, you canchange the port assignments here.5. Select the Disable Setup Protocol check box to disable it.NOTE No programs are currently available to use the Setup Protocol with ePDU. It is safe to leave thisdisabled.6. Click Apply. The settings are modified.
