USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−2008762. Type a new name in the Device Name field.3. If DHCP is selected for IP configuration, the name entered in the field orPreferred Host Name (DHCP only) will be registered with DNS and used on theassigned IPs by DHCP.4. Click Apply. The ePDU is renamed.Modifying the Network SettingsThe ePDU was configured for network connectivity during the installation andconfiguration process (see Chapter 4, Installation and Configuration" for details). Ifnecessary, you can modify any of these settings. To do this:1. Select Device Settings, and then select Network. The Network Settings pagedisplays. The left side of the page consists of the Basic Network Settings panel,which displays the current network settings (see Figure 73).2. Do one of the following: Auto configuration: To auto configure the ePDU, select DHCP or BOOTP from theIP Auto Configuration list. If you select DHCP, you can also enter a preferredhost name (this is optional). Static IP: To enter a static IP address, select None from the IP Auto Configurationlist, and then enter:IP addressSubnet maskGateway addressPrimary and (optional) secondary DNS server addresses3. Click Apply. The network settings are modified.