USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−200878Modifying the LAN Interface SettingsThe LAN interface speed and duplex mode were set during the installation andconfiguration process (see Chapter 4, Installation and Configuration" for details). Tomodify either setting:1. Select Device Settings, and then select Network. The Network Settings pagedisplays. The LAN Interface Settings panel on the bottom right shows the interfacespeed and duplex mode. See Figure 75.Figure 75. LAN Interface Settings Panel2. To change the interface speed, select the speed you want from the LAN InterfaceSpeed list. Your choices are: Autodetect (system selects optimum speed) 10 Mbps 100 Mbps3. To change the duplex mode, select the mode you want from the LAN InterfaceDuplex Mode list. Your choices are: Autodetect (system selects optimum mode) Half duplex Full duplexHalf duplex allows data to be transmitted to and from the ePDU, but not at thesame time. Full duplex allows data to be transmitted in both directions at thesame time.4. Click Apply. The settings are modified.
