USING THE WEB INTERFACEEATON Managed ePDU User’s Guide 164201xxx Rev 1 DRAFT 10−OCT−200880Configuring the SMTP SettingsThe ePDU allows you to configure alerts to send an email message to a specificadministrator. To do this, you have to configure the ePDU SMTP settings and enter anIP address for your SMTP server and a sender’s email address.NOTE See Setting Up Alerts" on page 62 for instructions on configuring alerts to send email.1. Select Device Settings, and then select SMTP Settings. The SMTP Settings pagedisplays (see Figure 77).Figure 77. SMTP Settings Page2. Type the IP address of the mail server in the SMTP Server field.3. Type an email address in the Sender Email Address field.4. If you SMTP server requires password authentication, type a user name andpassword in the User Account an Password fields.5. Click Apply. Email is configured.6. Now that you have applied the SMTP settings, you can test them to ensure thatthey work correctly. To do this, type the receiver’s email address in the ReceiverAddress field and click Send.NOTE Do not test the SMTP settings until you have first applied them. If you do, you will lose the settingsand be forced to re−enter them.